Call Us Today 770-708-7247
678-753-4822
678-799-1200
Work Hours Mon-Sun
8AM-10PM
Mail all your Payments to: 4575 Webb Bridge Road, Ste. 4586, Alpharetta, GA 30023 11950 Jones Bridge Road, Suit 116, Alpharetta, GA 30005
Close
Mail all your Payments to: 4575 Webb Bridge Road, Ste. 4586, Alpharetta, GA 30023 11950 Jones Bridge Road, Suit 116, Alpharetta, GA 30005
770-708-7247
678-753-4822
678-799-1200
usaircontractors@gmail.com

Combustion Theory And Optimization

Combustion Theory And Optimization

 

DID YOU KNOW?

How many Heating Contractors or HVAC Technicians understand Combustion Theory And Optimization? Not many. Now hold your fire, we’re not saying they don’t know their stuff; we’re suggesting there is a lack of awareness in regard to Combustion Theory And Optimization. Because we’re well versed with Oil and Gas Combustion, we believe we have some say on this subject.

Most every person in the world of heating relies quite heavily on the old “Net Flue Temperature and Co2” method of determining the Combustion Efficiency. Every Oil Burner Technician out there at one point in time held a slide chart in his hand for the first time that enabled him to determine this. But, this is not Mother Nature. There is a succinct problem with this well-accepted practice: the lower the flue temp equates to a higher efficiency. Doesn’t this defy physics? It does! Consider this: a heating appliance’s role in life is to transfer heating energy into a heating medium (water or air). If the flue gas temperature is close to or even below the discharge temperature of the Gas Furnace, how on earth can heat be transferred? Well, it is, but the wrong way!

Here is how you know if your Heating Technician knows their stuff: if they check the operation of your Gas Furnace, Boiler, or Hot Water Heater with Digital Combustion Analyzer, you’re in luck; they might know what they’re doing! Unfortunately, this subject is simply not grasped by perhaps 95% of HVAC Technicians. So enough with the small talk you say? Here’s a trick question. What’s more efficient: a 92% AFUE Gas Furnace with a o2 reading of 10.2% or an 85% AFUE Oil Fired Boiler with an o2 ready of 5%? Oh, both appliances are the same BTU input. If you guessed oil, you’re correct.

Also, how do you know if the chimney is venting, or if there is enough Combustion Air? There’s a theory, like what the code book and installation manual says. And then there are real life conditions. Without good combustion training and good tools, there remain a lot of unknowns. Some of these unknowns may impact your Gas bill or even a little more serious. 

For further information or to talk with an US Air Contractors HVAC Design Engineer, call 678-753-4822(HVAC).